...

hecked and repaired the wind turbine brake on the morning of February 22, 2008. At the last routine inspection it was noted that the main gear of the turbine was also making unusual noises and a sophisticated endoscopic inspection of the gear was planned, but as result of its high cost it was not undertaken immediately. After repair and several checks of the brake, the turbine was restarted in order to bring it back into normal operation. At this time the wind was very strong. The airbrakes at the tip of the blades were turned on to control the speed of the turbine before it reached operational speed. After its generator was synchronized to the grid a noise from the nacelle prompted an attempt to stop the turbine manually. A large crashing sound occurred, possibly as a result of the gear failing, at which point the turbine began to oscillate strongly. The rotor then suddenly stopped but immediately started turning again. The rotor did not at first turn very fast, but it was now impossible to control the speed of rotation. The tower was evacuated immediately, the airbrakes of the turbine had failed and as a strong wind blew the turbine started rotating faster and faster quickly reaching a speed far beyond its design tolerances. Service personnel contacted the police who established a security cordon of 400 metres around the turbine. 2.5 hours later, at about 3:20 pm, the blades began to disintegrate. One of the blades hit halfway along the tower which bent in the direction of the wind. The top half of the tower then sheared off at the bend and fell to the ground. The base of the tower remained standing. The debris of the turbine flew 200–500 metres away. No injuries were caused. The collapse was filmed from a nearby farmhouse. The film was shown on several TV stations and is available online. The turbine was out of service until June 2008 and was eventually replaced by a new wind turbine of the same design.